- Unit: °C (°F)
- If value -40 (-40): sensor circuit open
- If value 140 (284): sensor circuit shorted
| Last Modified: 11-29-2007 | 1.6 U | |
| Service Category: Vehicle Interior | Section: Meter/Gauge/Display | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002Z4S005X |
| Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: DATA LIST / ACTIVE TEST (2008 Sequoia) | ||
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream ON.
(d) Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.
(e) According to the display on the Techstream, read the Data List.
Combination Meter
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
Tail Cancel SW*1 |
TAIL cancel switch condition/ON or OFF |
ON: TAIL cancel switch ON OFF: TAIL cancel switch OFF |
- |
|
ODO/TRIP Change SW |
Trip switch (ODO/TRIP switch) condition/ON or OFF |
ON: Trip switch (ODO/TRIP switch) pushed OFF: Trip switch (ODO/TRIP switch) not pushed |
- |
|
Vehicle Speed Meter |
Vehicle speed/Min.: 0 (0), Max.: 255 (158) |
Almost same as actual vehicle speed (when driving) |
Unit: km/h (mph) |
|
Engine Rpm |
Engine speed/Min.: 0, Max.: 12750 |
Idling: 650 to 750 |
Unit: rpm |
|
Coolant Temperature |
Engine coolant temperature/Min.: 0 (-40), Max.: 140 (284) |
After warming up: 80 to 100 (176 to 212) |
|
|
Washer Switch |
Washer switch/ON or OFF |
ON: Washer switch ON OFF: Washer switch OFF |
- |
|
+B Voltage Value |
+B voltage/Min.: 0, Max.: 25.5 |
Below 1 to 14 |
Unit: V |
|
Integrated value for Oil Maintenance |
Integrated value for oil maintenance warning/Min.: 0 (0), Max.: 25500 (41037) |
0 (0) to 25500 (41037) |
Unit: mile (km) |
|
Fuel Input |
Fuel sender gauge input/Min.: 0, Max.: 127.5 |
Fuel sender input value |
Unit: L |
|
Ambient Temperature |
Ambient temperature/Min.: -40°C, Max.: 87.5°C |
Same as outside temperature |
Unit: °C (°F) |
|
Rheostat value |
Light control rheostat switch input/Min.: 0, Max.: 100 |
Light control rheostat switch is Dark (0) → Bright (100) |
Unit: % |
|
Quantity of Outside Light |
Outside dimmer output/Min.: 0, Max.: 100 |
0 to 100 |
Unit: % |
|
Communication ECM/Meter DTC 1 |
ECM communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ECM ODO (History 1) |
ECM odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Communication ECM/Meter DTC 2 |
ECM communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ECM ODO (History 2) |
ECM odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Communication ECM/Meter DTC 3 |
ECM communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ECM ODO (History 3) |
ECM odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Communication ABS/Meter DTC 1 |
Skid control ECU communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ABS/VSC ODO (History 1) |
Skid control ECU odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Communication ABS/Meter DTC 2 |
Skid control ECU communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ABS/VSC ODO (History 2) |
Skid control ECU odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Communication ABS/Meter DTC 3 |
Skid control ECU communication stop history/Rec or Unrec |
Rec: DTC is recorded Unrec: DTC is not recorded |
- |
|
ABS/VSC ODO (History 3) |
Skid control ECU odometer history/Min.: 0, Max.: 999999 |
With history: 0 to 999999 Without history: ffffffh |
- |
|
Key Remind Sound |
Key reminder sound/FAST, NORMAL or SLOW |
Displays key reminder buzzer speed setting |
- |
|
Key Remind Volume |
Key reminder volume/LARGE, MEDIUM or SMALL |
Displays key reminder buzzer volume setting |
- |
|
Driver Side Warning Buzzer |
Front driver side seat belt warning buzzer setting/ON or OFF |
ON: Front driver side seat belt warning buzzer ON setting OFF: Front driver side seat belt warning buzzer OFF setting |
- |
|
P-Seatbelt Warning Buzzer |
Front passenger side seat belt warning buzzer setting/ON or OFF |
ON: Front passenger side seat belt warning buzzer ON setting OFF: Front passenger side seat belt warning buzzer OFF setting |
- |
*1: w/ TAIL cancel switch
Engine
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
Engine Speed |
Engine speed/Min.: 0, Max.: 16383 |
Idling: 650 to 750 |
Unit: rpm |
|
Vehicle Speed |
Vehicle speed/Min.: 0 (0), Max.: 255 (158) |
Actual vehicle speed |
|
|
Coolant Temp |
Engine coolant temperature/Min.: -40 (-40), Max.: 140 (284) |
After warming up: 80 to 100 (176 to 212) |
|
ABS/VSC/TRAC
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
(FL/FR/RL/RR) Wheel Speed |
Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202) |
Actual wheel speed |
Similar speed as indicated on speedometer |
2. ACTIVE TEST
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream ON.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Combination Meter
|
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Speed Meter Operation*7 |
Speedometer |
0, 40, 80, 120, 160, 200, 240 or 280 |
Perform the test with the vehicle stopped and engine idling |
|
Tacho Meter Operation |
Tachometer |
0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 |
Perform the test with the vehicle stopped and engine idling |
|
Fuel Meter Operation |
Fuel receiver gauge |
EMPTY, 1/2 or FULL |
Perform the test with the vehicle stopped and engine idling |
|
Water Temperature Meter Operation |
Engine coolant temperature receiver gauge |
LOW, NORMAL or HIGH |
Perform the test with the vehicle stopped and engine idling |
|
Volt Meter Operation |
Voltmeter |
0, 3, 6, 9, 12, 15 or 18 |
Perform the test with the vehicle stopped and engine idling |
|
Oil Pressure Meter Operation |
Oil pressure receiver gauge |
LOW, 1/4, 1/2, 3/4 or HIGH |
Perform the test with the vehicle stopped and engine idling |
|
A/T Indicator operation 1 |
A/T indicator (normal mode) |
P, R, N, D, 4, 3, 2, L |
Perform the test with the vehicle stopped and engine idling |
|
A/T Indicator operation 2 |
A/T indicator (sequential mode) |
Es, 5*5 or 6*6 |
Perform the test with the vehicle stopped and engine idling |
|
Meter Display 1*8 |
All dots in the multi-information display |
ALL or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Airbag |
SRS warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Doors All Open |
All doors open light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Front Passenger Side Seat Belt |
Passenger side seat belt warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Driver Side Seat Belt |
Driver side seat belt warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp ABS |
ABS warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp VSC |
VSC OFF indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Slip |
SLIP indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Beam |
BEAM indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Head*1 |
HEAD indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Tail*2 |
TAIL indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Fuel |
Low fuel warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Tire Pressure Warning System |
Tire pressure warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
A/T Oil Temperature Operation |
A/T OIL TEMP warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. 4WD |
4WD indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Cruise |
CRUISE main indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Lamp Brake |
Brake warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. EPS |
EPS warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Oil Maintenance*3 |
Oil maintenance warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Master Warning*4 |
Master warning light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
|
Indicat. Auto LSD |
AUTO LSD indicator light |
ON or OFF |
Perform the test with the vehicle stopped and engine idling |
*1: for U.S.A.
*2: except U.S.A.
*3: w/o Multi-information display
*4: w/ Multi-information display
*5: for 2UZ-FE
*6: for 3UR-FE
HINT:
*7:
- It is normal that door will be locked automatically when performing the speedometer Active Test.
- The displayed value has the same units (km/h, mph) as the main scale of the vehicle speedometer.
- The needle position should be within the acceptable tolerance.
*8: If this Active Test is being performed and the ignition switch is turned off and then ON, the A/T and ODO/TRIP display background may turn white. If this occurs, end this Active Test and turn the ignition switch off.
|
|